Recent content by Jac123

  1. Jac123

    Garmin 440 s

    It's an old unit and I assume it may be time to replace it but I was hoping for another year or two before replacing.
  2. Jac123

    Garmin 440 s

    Our Garmin begins to power up and then fades to a blank screen. Has anyone had a similar experience and was there any easy fix?
  3. Jac123

    Detector Suggestions

    I have a 1989 Catalina 30' with a propane stove and a diesel engine. I am looking for suggestions for battery operated combination detectors.
  4. Jac123

    Pedestal

    Thanks Ken
  5. Jac123

    Pedestal

    This is a pic from the internet that shows the 2 screws over the shafts. Those are the ones I have a question about. t
  6. Jac123

    Pedestal

    I am having a problem with my throttle not holding a constant speed- I found this photo with the adjustment bolt circled in red.I am going to adjust that but my question is what are the screws right next to it on the throttle housing for and the one on the gear housing. Should they be tight? Thanks
  7. Jac123

    1989 Catalina 30

    Tried the coconut oil today- Went on easy and looks good. Thanks Hayden.
  8. Jac123

    1989 Catalina 30

  9. Jac123

    1989 Catalina 30

    I have a 1989 Catalina 30 with a faded interior. Any suggestions on the best product to spruce up the wood?
  10. Jac123

    Heat Exchanger Support

    Thanks to all who replied. I bought the kit from Catalina Direct. Installed the left support and tighten up the bolt on the right support. All seems good to good.
  11. Jac123

    Heat Exchanger Support

    M25xp Thanks for the info
  12. Jac123

    Heat Exchanger Support

    When I was changing out the pencil zinc I noticed 1 of the supports had broken free. Any suggestions on the best way to reattach it will be appreciated.
  13. Jac123

    Mast Discoloration

    I have a stain around the base and pulleys on my mast. Anyone know the cause?
  14. Jac123

    1989 Catalina 30 Hot Water Heater Removal

    Thanks Hayden- I took the drawers and frame out late yesterday but it still looked tight with a depth sounder the po had installed. I will measure all up this weekend. Thanks for your reply