JK_Boston - 5/16-inch ID for fuel supply and return 50 feet did the whole boat. 5/8-inch ID for the vent about 6 feet.
marchem - On a similar note-while working on our engine recently I bent and cracked the fuel return line from the injector block. It’s 3/16” ID (is this line different...
Your the man Stu Jackson !!!
Much appreciate your response and info.
Hope you get some sailing in this season. Here in Toronto we get to launch June 6 with distancing. That will be a sight to see.
Thanks again and stay safe and healthy.
Does anyone happen to know what the I.D. & O.D. & length of the BUSHING that fits in the Goose Neck fastened to the mast. It was lost when the boom and mast where take off at haul out. The picture attached is what it looks like.
2 Old Pirates
14mm I.D (9/16")
JK_Boston ....... could you put up a picture when you have the time and chance. Is there a mount that you can mount and then screw the bolt into the mounts from above. I was looking at cutting the bolts one at a time.
Food for thought.
I'm replacing my hoses also. Was told by BETA engines that cheaper hoses get soft inside and the clamps only work for a while and then small amounts of air gets sucked in and create air in your line. Then you have to bleed it. Better to get new hoses.
Glad I noticed this request. I needed to...
I found this fuel hose for replacement. Trident A1-15 (which seems to be recommended )........ now does anyone happen to know the inside diameter of the hose that fits on the nipples of the UNIVERSAL - M-25XPB.
2 OLD PIRATES