Rouging out some starboard to fit electronics (covering a square hole and a round one).
This is me with my boarding ladder disassembled, fitting a plywood backer to it, and pre-drilling the holes. I later epoxied (actually poly resined) the board before installation.
Electronics installed no, I love how this turned out.
Hatchboard keepers installed, black 1/4" starboard.
Rouging out some starboard to fit electronics (covering a square hole and a round one).
Testing the ladder install, and location... this is held in ONLY by 2 temporary screws in this picture, I still need a backer plate and large bolts to secure it.
Painting the daggerboard, yep its still about 2-3" in the hole but enough room to reach down and paint ALL but the bottom, I'll paint the bottom when the daggerboard is down again, also while I recoat the bottom... This is VC17m.
Finding a way to haul out the daggerboard all 600lbs of it... to paint it.
shnool

Rouging out some starboard to fit electronics (covering a square hole and a round one).

There are no comments to display.

Media information

Album
S2 gets an overhaul...
Added by
shnool
Date added
View count
324
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
24132-1430924360-deb6d56ecf09907b5eaadc2b7bfe2e2b.jpg
File size
30.3 KB
Dimensions
450px x 800px

Share this media

Top Bottom