DSC00780 It's important to secure the pole to the mast so that it doesn't pull off when the mast is up.
DSC00451 This is a detachable mast crutch that I use for trailering.
DSC00447 This is a Johnson Handy-Lock.
DSC00783 This is my old wooden Gin Pole. I'm using a stainless steel Gin Pole now.
DSC00780 It's important to secure the pole to the mast so that it doesn't pull off when the mast is up.
DSC00781 This first Gin Pole that I built was made of Oak. I made so that it could be taken apart for easy stowage. If you decide to build one of these it would be wise to have your mast raised so that you can decide where you want to place it on the mast. I place the crutch of the Gin Pole on my mast and tie it off just about even with the Goose Neck. This height will allow me to take up on my block and tackle and I'm using my boom vang with about 55' of braid line attached to it. This gives me enough line to stretch the blocks out. Figure on making the Gin pole long enough to be within an inch or two from the forestay when it's in place on the mast. The Gin Pole just provides the angle needed to raise/lower the mast and that's all. Some guys mount a small boat winch on the Gin Pole and use it to raise/lower the mast. Myself, I prefer the block & tackle or my Boom Vang.
DSC00450 As I had mentioned previously, you need some sort of a mast crutch to hold the mast up off the cabin while you pin the tabernacle. A small roller in the mast crutch will allow you to roll the mast forward or aft. I was fortunate to get a full stern rail on my new O'Day 222 only because I requested it. They only install about 20 of these on these boats that year so I'm told. I had a welder make me up that mast crutch to my existing rail. He only charged me about $230 back then I think. I built that wooden crutch and later added the roller. My friend Wayne Barlow gave me the idea of having a roller in the crutch. I had been lifting my mast and walking it back to the crutch and putting it in place-- like a dumbbell. Heck it's easier to roll it back and forth.
DSC00442 I used to have to raise the crutch to a higher position before I started using the Gin Pole but having a Trex block under my mast tabernacle now allows the height needed over my closed companionway hatch to leave the crutch all the way down.
Joe11688

DSC00780 It's important to secure the pole to the mast so that it doesn't pull off when the mast is up.

There are no comments to display.

Media information

Album
Gin Pole pics
Added by
Joe11688
Date added
View count
751
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
19263-1375557660-f7d1390fabf9d74f892f3089e0f0a753.jpg
File size
129.8 KB
Dimensions
800px x 600px

Share this media

Top Bottom