I had posted a previous topic about the corroded toggle for my furler. I am now ready to replace it. When I took everything apart, I let the furler extrusions slide down the headstay. The directions state to attach the jib halyard just under the feeder to prevent this from happening, I guess I didn't have it tight enough. Has anyone had this situation and repositioned the furler extrusions. I think all I have to do is to pull up on the jib halyard which is attached just beneath the feeder and reposition the furler extrusions so I can put the stop pin back in. Like with most things that I am not familiar with I don't want to create another problem. Any suggestions.
Thanks,
Mark
Thanks,
Mark