While I was chasing down a top-side water leak on our Hunter 45DS (found it I think - the forward-most port side stanchion needed to be re-bedded), I needed to gain access to the top and bottom hull joint in the forward cabin. The area I needed to access was underneath a sizeable plastic cover that extends down from the port-side headliner to the beginning of the wall covering on the port side. There were three screws in the lower part of that piece that I removed, which allowed me to pull the plastic piece away from the wall covering enough to gain "marginal" access to the stanchion nuts so that I could remove and re-bed the offending culprit. What I couldn't determine was how to get that whole piece off in order to gain access to the area for a thorough inspection. Has anyone ever removed this piece before, and if so could you let me know how it is attached around the headliner? My guess is either a screw or staple into the headliner frame. Since I've never had to remove the headliner any pointers there would be appreciated as well.