My ST60 wind gauge and masthead unit bit the dust. I have purchased an i60 unit to replace it, but have read that installing it and connecting it to the other ST60 instruments can be a challenge. Has anyone done this and got any tips? Thanks, all.
If he has a ST60 wind transducer run to that spot it will plug straight into the i60. The i60 range was designed to be the crossover from ST60s into the NMEA2k/SEATALKng world. As other note you'll need a converter to ng, but is is a simple $100 dongle.
Thanks, everyone - I will be plugging it into an existing ST60 navpod and don’t think I will need to pull cable or wire. I have the converter kit coming, too.
You have to drill some new holes for the mounting screws to go thru so have a drill ready. Otherwise it fit right into the old mounting hole.
I re-used my old wires and old vane on top of the mast. No issues.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.