Hi,
I’m reinstalling a rebuilt Spinlock XA Clutch and one of the screws could not go in further beyond 1/4” into the thread. Please see photo attached.
I suspect I must cross threaded it. There is no access panel in the head liner to work on.
Any ideas /suggestions how to proceed?
Thanks,
Chew
I’m reinstalling a rebuilt Spinlock XA Clutch and one of the screws could not go in further beyond 1/4” into the thread. Please see photo attached.
I suspect I must cross threaded it. There is no access panel in the head liner to work on.
Any ideas /suggestions how to proceed?
Thanks,
Chew