Anyone ever successfully install a shoot thru depth finder in a 240? If so, where did you place the puck? This guy isn't drilling a hole in a perfectly good boat. Thanks in advance.
H240 shoot thru hull transducer
- Thread starter Drew13440
- Start date
Hope this helps. It's in the manual.
https://sbo.sailboatowners.com/downloads/Hunter_240_16790565.pdf
https://sbo.sailboatowners.com/downloads/Hunter_240_16790565.pdf
Attachments
I installed a shoot thru hull transducer in my H26 next to the bilge pump. Looking at the 240 owners manual, it looks like the setup is very similar. You should be able to install one there.
https://hunter.sailboatowners.com/mods.php?task=article&mid=15&aid=100036&mn=26
It's not necessary, but I used one of these. It allows you to compensate for the angle of the hull, pointing the transducer straight down rather than on an angle. The inside is filled with mineral oil. You could go buy a new wax toilet ring and stick the transducer to the hull first before making a permanent installation.
https://www.westmarine.com/buy/garm...ull-transducer-8-pin--13178512?pCode=13178512
https://hunter.sailboatowners.com/mods.php?task=article&mid=15&aid=100036&mn=26
It's not necessary, but I used one of these. It allows you to compensate for the angle of the hull, pointing the transducer straight down rather than on an angle. The inside is filled with mineral oil. You could go buy a new wax toilet ring and stick the transducer to the hull first before making a permanent installation.
https://www.westmarine.com/buy/garm...ull-transducer-8-pin--13178512?pCode=13178512