Replacing factory rope/wire halyards with just rope. I bought 7/16 but the manual lists 3/8. Now I am a little nervous about my decision to go up a mere 1/16 of an inch. Anyone else running all rope and if so anyone running 7/16?
The limiting factor will be the halyard sheave's rope channel diameter.... Check your owner's manual parts guide... I'm probably stating the obvious here. If you're the least bit apprehensive I would exchange for 3/8" ... if possible.
They are custom. I don't know why I bothered to upsize them. Worst case I will run one up and see how it works. If it seems to bind at all I will pull it back down.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
