2004 Hunter 41 Interior Stain
- Thread starter spadaforaj
- Start date
My 2004 H36 has pecan stain finish. Just finished staining partial panel in V-berth due to water stain. Near perfect match. The next best stain choice was Gunstock.
Any time trying to clean up the wood in a boat or RV is a trial and error getting small cans of stain to use on the wood and pretty sure most older boats have teak and do to water staining or just
wear and fading will make the teak darker.
Nick
wear and fading will make the teak darker.
Nick
The Owners Manual has instructions for how to repair woodwork:
REPAIRS
When woodwork is damaged from scrapes or abrasions that go into or thru the finish, take the following steps:
1. Take 180 to 200 grit wet/dry sand paper to smooth out rough spots.
2. Wipe clean of dust and dirt with a clean rag. Note: before applying oil, wood surface
must be dry.
3. Wipe or brush on oil, allow to penetrate 5-15 minutes while surface is still wet.
4. Sand until smooth with 400A wet/dry sandpaper.
5. Wipe dry with a clean rag. Allow 8-12 hours drying time.
6. Apply second coat, sand, and repeat procedure.
This procedure may be repeated as many times as needed to bring damaged area back to its original finish. If you have trouble with getting the same sheen, you may use a soaked and wrung out cloth to apply a very light coat to get an even sheen.
For more information about the product contact:
Dalys
3525 Stoneway North
Seattle, WA 98103
(206) 633-4200
REPAIRS
When woodwork is damaged from scrapes or abrasions that go into or thru the finish, take the following steps:
1. Take 180 to 200 grit wet/dry sand paper to smooth out rough spots.
2. Wipe clean of dust and dirt with a clean rag. Note: before applying oil, wood surface
must be dry.
3. Wipe or brush on oil, allow to penetrate 5-15 minutes while surface is still wet.
4. Sand until smooth with 400A wet/dry sandpaper.
5. Wipe dry with a clean rag. Allow 8-12 hours drying time.
6. Apply second coat, sand, and repeat procedure.
This procedure may be repeated as many times as needed to bring damaged area back to its original finish. If you have trouble with getting the same sheen, you may use a soaked and wrung out cloth to apply a very light coat to get an even sheen.
For more information about the product contact:
Dalys
3525 Stoneway North
Seattle, WA 98103
(206) 633-4200