hunter 33

Hello mates. I am in the process of removing my propeller. I also want to replace my Shaft Bearing (Cutlass Bearing). Does anyone have dimensions of the bearing. (1980 Hunter 33) Also has anyone removed the shaft's strut before? If so my next question is, is it difficult getting the shaft...

Am I correct that water from the galley and head sinks drain directly to the ocean via a throughfitting under the waterline? What about the shower? I have a sump pump panel switch, a sump pump switch under the lip of the head sink (no idea which position is on or off) and a jabsco 50psi model...

I found a split in my rudder today while doing a winter bottom inspection. I need advise on repairing the damage. Do I drop the rudder or can I grind and fill this crack with epoxy? This is a 2005 Henderson model Hunter 33.

Hi, have finally sold my last motorboat (too many headaches, fumes, noise and fuel bills!!) and I’m looking for my first sailing boat. I have seen a lovely 2006, Hunter33, bilge keel, in mast furling, Yanmar30, new standing rigging 2019, new sails 2018... she looks great, .....as a first sail...

The original charger was heated and destroyed. I bought a new and assembled external assembly. ____________________________________________________ Building a cabinet in a cockpit:

The original charger was heated and destroyed. I bought a new and assembled external assembly. ____________________________________________________ Building a cabinet in a cockpit:

We are away from the boat and we need to know the length and breadth of a 2006 Hunter 33. If anyone knows or is close enough to their boat to measure it your help would be very much appreciated. Thanks, Harry Schell

I would like to shorten my mast on my Hunter 33. The mast has the furling mainsail system. Has anyone shortened one of these mast? Where did you get it done? Did it work out ok?

My boat sunk. It has been brought back to life. The existing yanmar engine and trans are toast and must be removed. Will a yanmar 3gm30 fit?

I am planning to change antifreeze in the cooling system of my Yanmar 3YM30 (the closed circulation, not the sea water). I could find in the engine manual the coolant capacity, but that does not include the volume of the coolant circulating through the water heater. Does anybody know what extra...