hose

  1. newimaging

    1-1/2" Hose Tee fitting below waterline

    Hi there, I was wondering if anyone has a recommendation where to find a 1-1/2" Hose Tee fitting that is appropriate for under waterline use. I am replacing the cockpit drains on my Hunter 22 (1980's). The old hose leaked and just found out the Tee has cracks in it. Probably the original almost...
  2. R

    Pump for washing the deck

    We have found it necessary at times to wash the deck, grill, and other parts of the boat while we are out sailing for a few days. Spilt wine and food, fish drippings, and dirty feet marks. I was thinking of throwing a bilge pump overboard and using the hose. Figure that's better than my...
  3. SVPardonMyFrench

    CNG/LPG gas hose

    I am in the process of converting from CNG to LPG and trying to trace the hose that runs from the tank in the port lazarette to the stove. Before I remove all the floorboards etc... thought I would ask if someone had any insights? thanks much! Frederick
  4. JamesG161

    Spring Check Out

    Although Spring is not early, today was a nice 80° sunny day on the Gulf. We began the preparations for a Safe Sailing 2018. We always start with the seacocks, hoses, and clamps that could sink our boat or a least cause a major disruption in a nice sailing adventure. _____ Look what we found...
  5. eusjim1

    Head hose sealing problem

    Replaced head and all hoses. Hoses are 1 1/2 inch New Shields Sanitation hose with flat interior. Had to heat up with hot water to get over some fittings. Used stainless clamps. Most connections leak.. What am I doing wrong?
  6. I

    Trouble replacing hose from engine to muffler

    I believe I need to replace the hose running from my engine to my muffler. The piece in question is very short and rigid and I don't see how I can get the old one out and the new one in. muffler pic.jpg I have enclosed a picture. It is taken after I took out the aft seat around the dining...
  7. P

    Help removing waste pump-out tube

    Hi there! My black water tank is full (and slightly filling into the toilet leaving a stink) on my Catalina 30 but the stainless waste pump-out cap froze onto the stainless thru-deck housing. I have tried hammering with a large screwdriver but no luck. I bought a new filler cap and housing but...
  8. A

    1970s-1980s Hunter 25 - Bilge Help?!?!

    Just purchased a 1980 Hunter 25; am fixing some odds and ends and gearing up for maiden voyage. I have a question regarding the bilge. It has a small bilge area in the cabin accessed by two wood panels; there is no pump on this boat (and from the old schematics it didnt come with one from the...
  9. Sailor_Jeff

    Changing Scupper Hoses on 28.5

    I have leaking scuppers on my 28.5. Has anyone one ever changed the scupper hoses (cockpit drain hoses) on a hunter 28.5? Just how did you access the hose fittings? Did you install deck-plates in the rear wall? Jeff
  10. Sean5306

    1 or 1 1/2 inch Head to Holding Tank Lines?

    I'm overhauling the sanitation system in my Hunter P42. The original lines running from the old Jabsco toilet to the holding tank are 1 in lines. I understand from reading many forum posts that 1 1/2 in lines are common in sanitation systems. And, the line from the holding tank to the...