cutlass bearing

  1. F

    Cutlass Bearing for Beneteau 36cc

    I am in desperate need to replace the cutlass bearing on my 2000 Beneteau 36cc and I found a dealer who may have what I need - since ordering one from Beneteau parts right now is impossible due to their systems breakdown. Has anyone done this before and/or would you know the specs? I know it's...
  2. LawsonL

    Hunter 456 cutlass bearing

    I am away from my boat but would like to take the proper Cutlass bearing with me to replace it when I get there. Does anyone know the exact dimensions of a Cutlass bearing for a 2002 Hunter 456? Thank you for your help. It saves me a big trip and extra short haul as I live almost 300 miles from...
  3. F

    Prop support strut on 1990 Hunter Legend 37

    We are working on replacing the cutlass bearing on our 1990 Hunter Legend 37. We would like to remove the shaft to complete the replacement, but we don't have room to drop the rudder. Is anyone aware if the four screws for the strut are into fixed plate or if there are backing nuts under the...
  4. pvtpotter

    Refit -Running gear

    Lots of good work done. New prop shaft, shaft log, cutlass bearing and engine mounts. Reconditioned prop and strut. Refastened. I have more before pics and a vid if how bad the shaft and log were. May post later. Thanks for looking.
  5. K

    87 Newport 28 MKII Cutlass Bearing help?

    I am trying to get an estimate for a cutlass bearing replacement and the yard needs to know the "shaft id" and the "shaft size" (diameter?). Anyone have original specs?
  6. JACKHEAPE

    Dropping the rudder on a Hunter 34

    Anyone have any tips on dropping the rudder on a Hunter 34? I have to replace the cutlass bearing and either have to pull the prop shaft or pull off the strut. The bearing is to corroded to press out (have tried with Strut Pro and hydraulic press). I am worried that the strut itself might be...
  7. I

    C&C cutlass bearing for a one inch shaft

    Does anyone know the outside diamater for the cutlass bearing installed on a 1981 era C&C 32 or C&C 34 with a one inch prop shaft? -- ID=1'', OD=??? thanks - Erik B
  8. I

    Cutlass Bearing replacement

    I have a 1981 C&C 32 with a 1" prop shaft. Does anyone know the size or part number of the replacement cutlass bearing? Has anyone had experience with the Strut Pro bearing removal tool? (This tool does not require the removal of the prop shaft.) - Thanks, - Erik B
  9. Jason Sprigman

    Cutlass bearing tool rental for 1986 Cal 33?

    Does anyone know where I could borrow/rent a cutlass bearing tool for a 1986 Cal 33?