Maybe I should change my screen name to "AnotherCrazyThought" but you folks gave me a lot of food for thought on my trailer so here goes. In my quest to make a very large trailerable boat (S2 8.0C), as easy and fast to setup as possible, how about a mast step that could be reduced in height to slack the rig tension. This would allow pulling head stay and forward lower pins without adjusting the turnbuckles. I've thought about quick release levers but it is difficult to get one under a roller furling drum so the drum is close to the deck. I'm planning to build a new short tabernacle style mast step that pivots on the same axis with the side stays, to eliminate loosening those turnbuckles, so I could fab other ideas into this project. The ultimate compression load is around 3000lbs before something else breaks. Working load is about 1000 lbs. I already know it's lunacy to change something that sorta works so any constructive ideas will be appreciated.